If you are a discerning home owner, then you may well not be satisfied by having wall to wall carpeting throughout the house. You may want to change things up a bit from room to room, and have a bit of textural difference throughout the house. If this is the case, you may well have gone for some sort of hard flooring in your home, which presents you with a few more mysteries in the home as far as cleaning goes; how do you get them clean? With the varying surfaces that harder flooring can be made up of, it can be tricky to know which method to go for, but in fact, there are ways in which you can apply the same cleaning methods to a variety of different floor surfaces, simply because the issues with these materials that prevents normal cleaning are the same across the board.

Getting the hard flooring in your home clean.

These problems will usually be within the categories of; too much water, abrasion, or chemical issues. Whilst it may seem that the only way to be sure of avoiding such problems is to use some sort of specialist cleaning materials, it is in fact a lot simpler than this! Have a look over how you can defeat these three hard floor cleaning issues with simple steps.

For a start, wood and stone flooring cannot be overly soaked with water. As absorbent materials, they will soak up water and this will warp and crack them over time. Obviously you need some water to clean most surfaces, but if there is too much applied, then the consequences could be disastrous. However, initially, you will not see much of an issue, bar perhaps a little water staining. If the residue water is left to keep building up every time you clean the floor, then the surface can become uneven and completely ruined. To avoid this, simply wring out your mop more thoroughly than you might before mopping a tile or linoleum floor surface. This will prevent any standing water sitting on the surface, and leave the water that is there to evaporate quickly, before it is soaked in.

When avoiding abrasion on the flooring, you simply need to get rid of anything that might scratch the surface of the material. With wood and stone flooring, light scratches can get water in, as they have taken off the finish, and this can look terrible, as well as compromising the surface’s defense against damage. It is pretty simple to prevent however, you simply need to sweep fairly often, and vacuum well before mopping. This will get up all dust and hard pieces of dirt that could cut into the surface of the floor. You will find that this also gets rid of a lot of the dirt that you would otherwise be pushing around with the mop, which will make the cleaning process a lot quicker.

The issue of chemicals reacting badly with the material that your flooring is made from sounds like a tough one to deal with. Certain cleaning products will be made up of acidic or alkali chemicals, which can strip the finish form certain floor surfaces, making them less resistant to water and damage. If you were wondering how to find a PH neutral cleaning product, you might be surprised to hear that you probably already have it by your sink; a couple of drops of dishwashing liquid in your mop bucket will be all you need to get most floors clean! Deep Cleaning.